![]() BE VERY CAREFUL THIS IS THE MOST LIKELY STEP TO BREAK YOUR LCD PANEL. You should be left with a blank back panel that only has the LCD screen and the LED assembly.įrom here flip it upright and use the flat head screwdriver to carefully pry the sheet metal clips away. Disconnect any cable connectors you can and lift away the power and LCD driver board and set aside we will take care of this in another step. From here just begin removing all the tape carefully so you don't tear any ribbon cables. You can then use a small screwdriver to take off the board that houses the buttons.įrom here you can flip the monitor over and the back should be easily removable revealing sheet metal brackets and many wires that are taped down to the LCD assembly housing. Once you get a few parts up you can use your hands and gently pull up rotating around the monitor as needed to get the whole panel off. ![]() you should hear plastic snapping sounds as it comes up. You then flip it over and with a small flat head screwdriver, you gently pry the lip of the face on the monitor up. ![]() this will dismount the display driver and power board brackets from the back panel. For the one I'm using, you begin by unscrewing the 4 screws on the back of the monitor. This portion of the tutorial will vary for people based on the monitor you select for your mod.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |